this post was submitted on 01 Jun 2025
26 points (96.4% liked)

homeassistant

14868 readers
3 users here now

Home Assistant is open source home automation that puts local control and privacy first.
Powered by a worldwide community of tinkerers and DIY enthusiasts.

Home Assistant can be self-installed on ProxMox, Raspberry Pi, or even purchased pre-installed: Home Assistant: Installation

Discussion of Home-Assistant adjacent topics is absolutely fine, within reason.
If you're not sure, DM @GreatAlbatross@feddit.uk

founded 2 years ago
MODERATORS
GreatAlbatross@feddit.uk
greatalbatross@lemmy.world
26
Devices continuously dropping off my ZigBee network (lemm.ee)
submitted 2 weeks ago by MrKurtz@lemm.ee to c/homeassistant@lemmy.world
31 comments fedilink hide all child comments
 

I recently setup my ZigBee network in Home Assistant, using a Conbee III with deConz on my Synology NAS.

I purchased a few Aqara Temperature sensors and a couple of Mini Switches.

I was able to get them to pair just fine, but they won't remain online for more than a couple days. They then drop off and I can't even reconnect them easily. I need to try to pair them again like 10 times before they come back online.

At this point I don't know if the problem is my network, the Conbee III, deConz, or the Aqara devices.

I don't know much about ZigBee, but a couple things that I tried so far were:

  1. Use a USB extender instead of connecting the Conbee III directly to my NAS.
  2. Bring the devices as close a possible to the gateway. I don't have a big home, so I don't think distance is a factor here, but still, I put of the sensors right next to the gateway, and it would still drop after a while.

Do you have any hints on things to try to get this fixed, or at least identify the problem?

you are viewing a single comment's thread
view the rest of the comments
[–] EarMaster@lemmy.world 3 points 2 weeks ago

Also: mains powered devices (lightbulbs, smart plugs, zigbee repeaters) will all act as a repeater in your mesh. Depending on your home it might help to add in a few of them. But keep in mind that this will not magically make your existing devices use them. When setting up your network always pair your permanent powered devices first so they can act as endpoints for your battery powered ones.