ntn888

Maybe I've been mind controlled, but I'm used to the algorithmic feed of youtube and reddit. The default simple reverse chronological method of mastodon is hard to use for me.

I'm not interested in reading each and every post, but prefer the most sensational ones upfront..

I've tried googling but couldn't find much apart from a third party website I had to put my login creds into..

Do you guys have a better solution for this?

cross-posted from: https://lemmy.ml/post/44422946

Just curious if any people make steady income from a side devblog? I know there are dedicated youtubers, but I'm not into that..

I've been blogging over 4 years but the reach is still poor, just wanna rethink my strategy..

Thanks!

HI

I'm looking to write a programming guide for general line cortex-M0 TI MSPM0G1106.. For C, covering the main peripherals, SPI, DMA etc..

Using the sphinx book structure.

I'm choosing to write this because, though there are good beginner books for STM32, there's none for TI..

I'm semi experienced in the field.

But I've written article series on other microcontrollers in the past in my blog. Anyone willing to critique them?

Many thanks :)

Here's a risc-v one: https://simplycreate.online/tags/ch592

I'm a long time reddit user.. I should say I'm quite hooked. But lemmy feels a lot quiet. My primary interests are electronics, embedded programming, piracy 😏 and selfhosting. Apart from the last community the others are quite deserted.

I'v been on and off since past 1 1/2 years. No change..

On the other hand Mastodon is going well. And I nurture the interactions there. Lemmy could be the same. I too feel Reddit is kinda on-to-your face and aggressive.

Hi, I have a home server (basically a NAS) currently running Debian. Basically it's configuration is as follows

• debian host running 3 VMs

• debian running inside each VM as docker host

I just manually install KVM on the host then docker on each VM after creating each of them. I documented the process so I know how to replicate it in case I need to rebuild.

I now dream of being able to automate the rebuild process using config files. I know this is done using Ansible.

But I've now heard of Talos.. (A thin layer for kubernetes) and intrigued. But I suppose I need a setup for the VM host to achieve automation through config files..

What setup are you guys using?

Thank you.

Thanks for all your suggestions! I've chosen to go with just bash scripting (given my simple setup) and keep the setup as it is.. Just gotta learn bash and virsh :)

For folks that are unable to port forward on the local router (eg CGNAT) I made this post on doing it via a VPS. I've scoured the internet and didn't find a complete guide.