Amateur Radio

1939 readers

8 users here now

General amateur radio (ham radio) chat, questions, and news

founded 2 years ago

MODERATORS

w0odl@lemmy.radio

Eliminating PoE interference (lemmy.radio)

submitted 3 weeks ago by early_riser@lemmy.radio to c/amateur_radio@lemmy.radio

7 comments fedilink hide all child comments

I have an Ethernet cable running PoE+ to a wifi access point outside my shack that is very close to my radios. It exhibits the typical QRM pattern, with birdies at regular intervals making a warbling sound when the rig is on SSB.

I've eliminated this problem before using chokes, but this cable is thicker (meant for outdoor use) and much closer, it runs along the same cable runway as my antenna feedlines.

I'm pretty sure the cable isn't shielded. I just bought the cheapest thing I could find on Amazon. I wouldn't trust it if it did say it was shielded. Anyway, would getting a higher category of cable help the issue? Should I try choking the cable at a different point? I did it at the switch end, not the AP end.

you are viewing a single comment's thread
view the rest of the comments

[–] early_riser@lemmy.radio 2 points 3 weeks ago (1 children)

Cat6 per the listing on Amazon, but I don't trust it.

[–] cmnybo@discuss.tchncs.de 2 points 3 weeks ago

Most cat6 is unshielded. Make sure you're using shielded cat6 and shielded connectors. Check it with a multimeter to make sure there is continuity from end to end too.