this post was submitted on 04 Dec 2025
126 points (100.0% liked)
Hacker News
3137 readers
605 users here now
Posts from the RSS Feed of HackerNews.
The feed sometimes contains ads and posts that have been removed by the mod team at HN.
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
There are some crazy plastics you can 3d print (with high end printers) like PEEK. Most consumer grade printers can't print those sorts of advanced materials that would be suitable. Most consumer resin prints are very brittle and not very suitable either.
If you ordered it from a print shop with the right equipment and materials, FDM printing should be fine.