Bought a pair of these on Amazon (Store page) with the intention to install Meshtastic on them. One of the reviews suggested that the correct firmware to install was the Lilygo T-Lora V2.1_1.6, so I used the web flasher to install it.
I've gotten as far as the screen above, but there's no select button. There are two controls, a momentary switch labelled RST on the store page, and an on/off switch. The on/off switch doesn't seem to do anything at the moment, and the RST switch just reboots the device.
It does not seem to be advertising a wifi network or bluetooth connection.
Is it looking for something connected to a particular GPIO pin?
UPDATE:
It showed up on the phone app despite not showing up on my PC or phone's normal bluetooth menu. Pairing requires you to enter a code shown on the OLED display (not the most accessible method) but once that's done it seems to work.
Did you try a press and hold / longer press on the button that doesn't do anything?
I’ve tried holding the RST button but it does the same as a quick press. The on/off switch can’t be held.