homeassistant

14929 readers

5 users here now

Home Assistant is open source home automation that puts local control and privacy first.
Powered by a worldwide community of tinkerers and DIY enthusiasts.

Home Assistant can be self-installed on ProxMox, Raspberry Pi, or even purchased pre-installed: Home Assistant: Installation

Discussion of Home-Assistant adjacent topics is absolutely fine, within reason.
If you're not sure, DM @GreatAlbatross@feddit.uk

founded 2 years ago

MODERATORS

GreatAlbatross@feddit.uk

greatalbatross@lemmy.world

Devices continuously dropping off my ZigBee network (lemm.ee)

submitted 2 weeks ago by MrKurtz@lemm.ee to c/homeassistant@lemmy.world

31 comments fedilink hide all child comments

I recently setup my ZigBee network in Home Assistant, using a Conbee III with deConz on my Synology NAS.

I purchased a few Aqara Temperature sensors and a couple of Mini Switches.

I was able to get them to pair just fine, but they won't remain online for more than a couple days. They then drop off and I can't even reconnect them easily. I need to try to pair them again like 10 times before they come back online.

At this point I don't know if the problem is my network, the Conbee III, deConz, or the Aqara devices.

I don't know much about ZigBee, but a couple things that I tried so far were:

Use a USB extender instead of connecting the Conbee III directly to my NAS.
Bring the devices as close a possible to the gateway. I don't have a big home, so I don't think distance is a factor here, but still, I put of the sensors right next to the gateway, and it would still drop after a while.

Do you have any hints on things to try to get this fixed, or at least identify the problem?

you are viewing a single comment's thread
view the rest of the comments

[–] anotherandrew@mbin.mixdown.ca 1 points 2 weeks ago

I don't know if that's the (entire) story -- the mesh is supposed to occasionally reroute based on the link quality of the individual nodes and the repeaters they can see.