3DPrinting
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![]()
Moderation policy: Light, mostly invisible
view the rest of the comments
That's what they are saying. Buy a PEI plate with a magnetic backing, remove the rest of the abs from your glass build plate and stick the magnetic pad on it. Then the pei goes on top.
I did this as an upgrade to my own printer.
That sounds like an option. It looks like the aliminum heater is quite thin, I estimate 1-1.5mm, so unlikely to be a good suface to mount a flexible sheet to?
You just stick the magnetic backing to the existing glass plate for flatness and rigidity. You might have to bump the heated temp 1 or 2 degrees to compensate for the additional thickness, and you may lose a couple of mm/s of print speed at the high end due to the additional weight. That said, it is a very cheap and easy to execute option.