3DPrinting

19102 readers

417 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: or !functionalprint@fedia.io

There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml

Rules

No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts

If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![]()

Moderation policy: Light, mostly invisible

founded 2 years ago

MODERATORS

j4k3@lemmy.world

andypiper@lemmy.world

GrayBackgroundMusic@lemmy.zip

Prints appear to be lifting in one corner. (europe.pub)

submitted 2 days ago by Setiyeti93@lemmy.ca to c/3dprinting@lemmy.world

28 comments fedilink hide all child comments

I'm trying to get back into 3d pruning after a long hiatus.

I found my old Anycubic Chiron, and thought I'd give it a go. Smaller prints seem fine. But anything longer than an hour. Come off like this. I say that what I mean is I excitedly take the multi hour print off the bed in excitement and for get to look at how it is.

The two longer prints definitely were at least in part still adhered to the print bed despite it being cold.

My next plan is to set a print away and check on it every hour or so and see if one side of the print has warped mid print (so far I've been printing before I go to bed, and only watching the initial couple of layers).

My guess it that the (pla+) filament is warping mid print... Its old I'll admit. But was stored in an airtight container with silica packs, and I dried it out before using. But any of your thoughts would be greatly appreciated!

you are viewing a single comment's thread
view the rest of the comments

[–] CmdrShepard49@sh.itjust.works 2 points 2 days ago

Maybe try using 70% or 91% IPA. 99% might evaporate too fast to give it a good cleaning.