this post was submitted on 14 May 2026
19 points (100.0% liked)

homeassistant

19455 readers
5 users here now

Home Assistant is open source home automation that puts local control and privacy first.
Powered by a worldwide community of tinkerers and DIY enthusiasts.

Home Assistant can be self-installed on ProxMox, Raspberry Pi, or even purchased pre-installed: Home Assistant: Installation

Discussion of Home-Assistant adjacent topics is absolutely fine, within reason.
If you're not sure, DM @GreatAlbatross@feddit.uk

founded 2 years ago
MODERATORS
 

cross-posted from: https://lemmy.world/post/46848072

I very recently became paralyzed in my left (and dominant) arm, fingers and foot, which believe it or not, was not planned for.

The timing was pretty bad, as I've just purchased a couple of ESP3266-boards, a soldering kit and two pressure mats with the the end goal of making a basic bad sensor (one mat for my girlfriend and my side). (Here's the guide I intend to follow: Make your own bed sensor)

The obvious issue is how one, as easily as possible, can accomplish this? Main issues right now are that I can't hold the board, the wires or anything in my hand.

Any and all tips are greatly appreciated.

you are viewing a single comment's thread
view the rest of the comments
[–] Zwuzelmaus@feddit.org 0 points 1 day ago

fumes from lead free solder make me feel ill

That's the (doubtful) aroma of the flux that's inside the wire, not the metal itself. You would touch only the metal with your lips.