Silfeed

Yeah, that was about 5 minutes into just printing a brim.

I have washed it a couple times and was getting the same results. I’ll try again just in case.

I’ll definitely take a look at the pei sheets, that’s the first I’ve heard of it. Thanks for the suggestion!

I might also try changing how the print sits on the bed to make it print more like a diamond instead of a square shape, since it’s always one of the back corners that start the lifting. Not actually sure it that would help but who knows

Makes sense, I’ll try that out. Thanks!

I’ll need to figure out how to make the mouse ears that everyone suggests. I haven’t actually made my own models before and the brim is automatically made with the creality slicer. I tried cura as well but that was doing weird things with the print if I recall so I went back to the creality one. If I can’t figure it out on there, I’ll see if cura gives me more options for that. Thanks for the info

I use pla or pla+. I’ve played around with the temps but usually to a higher temp. I’ve seen some suggest a lower temp so I’ll give that a try and see if it helps

The picture is actually the brim of the print. It hadn’t actually gotten to the first layer yet. I’ll have to figure out how to do the mouse ears since that seems to be a common suggestion.