Terrible bed adhesive. Cleaned the bed multiple times. Tried with and without glue sticks. It had over 2mm of deviation.
Prints would always warp on the right side where the aux fan was blowing on them.
dorkage
joined 2 years ago
I had a K1 Max I got directly from Creality in October.
It would print ASA okay, but PETG and PLA failed like 75% of the time.
Switched to a Sovol SV08 with a cartographer and I can't remember having a failed print since. I print almost exclusively in PETG now.
I flashed to mainline shortly after getting it. I didn't have any issues with stock firmware, only swapped because if the cartographer.
If you don't mind minor amounts of tinkering to get it good, it's been great since switching to the Cartographer.