zout comments on Any idea what causes this?

submitted 1 week ago by zout@fedia.io to c/3dprinting@piefed.social

7 comments fedilink hide all child comments

Printing on an Elegoo Centauri Carbon 2. This started happening recently. Printer is relatively new, and before I was printing with the filament I ordered along the printer. The prints with the errors occur since switching filament to stuff I ordered later, but I also saw it when I switched back.

you are viewing a single comment's thread
view the rest of the comments

[–] zout@fedia.io [S] 1 point 1 week ago (1 child)

So, after the comment by @Chais@sh.itjust.works I checked my slicer settings again, it turns out the nozzle size was somehow changed from 0.4 to 0.2. I'll do a test print with the nozzle size reset.

permalink

fedilink

source

hideshow 1 child comment

[–] zout@fedia.io [S] 2 points 1 week ago

It was the nozzle setting. No idea how I managed to change that, but here's the result, left with the wrong setting, right is the correct one.

permalink

fedilink

source

parent