137
Developer re-enables 3D printer features that Bambu Lab disabled, firm promptly threatens legal action — OrcaSlicer-BambuLab project now shuttered (www.tomshardware.com)
submitted 5 months ago by to c/3dprinting@piefed.social
31 comments fedilink hide all child comments
you are viewing a single comment's thread
view the rest of the comments
[–] 28 points 5 months ago* (last edited 5 months ago) (1 child)

After all week of seeing editorialized headlines I couldn't believe how [the stuff described in] the article kept getting worse. If I'm getting this right, they sent a C&D over literal open source (not just source available, GPL) repo being forked??!

  • permalink
  • fedilink
  • source
  • hideshow 1 child comment
    •
  • [–] 7 points 5 months ago* (last edited 5 months ago)

    I like the X1C I have because it's good hardware but I hate where they are going. If they behaved like this back when I bought it I would have just gone to another company. Shame, the hardware is great.

  • permalink
  • fedilink
  • source
  • parent