442
Just found this community, here’s my workbench I built! (europe.pub)
submitted 2 days ago by to c/woodworking@lemmy.ca
44 comments fedilink hide all child comments
 

Got a mini-lathe for Christmas last year and needed something to put it on. Hundreds of spinning tops and mushrooms later, I’m pretty sure it was worth it. Here’s a couple other things from my lathe.

My first bow turned out pretty nice I think

Mini bat for one of the neighborhood kids

you are viewing a single comment's thread
view the rest of the comments
[–] [S] 2 points 1 day ago (1 child)

Did you notice any less stability with adding wheels? More I think about it, it would be nice to pull it away from the wall for some projects, and I’ve always thought I should’ve built it just a few inches taller. Wheels would take care of both those things…

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 1 child comment
    •
  • [–] 1 point 1 day ago*

    it always had wheels, it was made for this purpose. I have solid benches against the wall if I need to really beat on something, and that my vise is mounted to

    that said, I still do most of my work on the rolling table, including planing, because it's just.. more than good enough.

    my garage floor is very not flat and so I do need to position the table so the legs all more or less touch at the same time, and sure there is some rocking because of racking of the foldable leg design, but again.. it's more than good enough.

  • permalink
  • fedilink
  • source
  • parent