3DPrinting
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![]()
Moderation policy: Light, mostly invisible
view the rest of the comments
Pretty interesting question as high quality and layer adhesion is required.
**TL;DR Polymaker Polyterra **
PETG: Good layer adhesion but stringing. If you can perfectly print it this would be my choice.
PP: Excelent layer ahdesion. Easier to print than PETG but painting might be difficult.
TPU: Somewhat combing the worst of PP and PETG for this application.
ABS/ASA: requires enclosed printer, ideally heated to at least 70°C.
PLA: Easy to print and work with. If the mechanical properties are good enough this is it.
Personally, I really like the Polymaker Polyterra. Gives pretty results, easy to sand and paint.