Running services, network usage, memory usage, bandwidth, disk I/O, successful logins, whether the thing is even alive, etc...
So far my only method has been "hope and pray".

you are viewing a single comment's thread
view the rest of the comments
[–] 5 points 1 week ago (3 children)

My primary monitoring system is Beszel, but since I just migrated from VMs to LXCs it can’t properly see the memory/CPU usage, so it just checks for disk usage and liveliness. Home assistant with Proxmox & Dockhand integrations gives me the rest of my monitoring needs.

  • source
  • hideshow 3 child comments
  • [–] 2 points 1 week ago

    I am also using Beszel after using checkmk. For me checkmk was way too complicated (but is also way more powerfull) to setup and maintain propperly. So I switcheed to beszel because it is much easier and good enough for my use case which is:

    • Is the thing running at all?
    • Disk full?
    • CPU, network, etc. on full throttle for some strange reason?
    • send me a mail if somethings wrong

    Besides that I don't need anything. The only thing missing is SNMP support to check switches, routers and AP's.

  • source
  • parent
  • [–] 1 point 1 week ago (1 child)

    I've been checking several other solutions before and Beszel just hits the spot.

  • source
  • parent
  • hideshow 1 child comment
  • [–] 1 point 1 week ago

    If you run Proxmox and Proxmox Backup Server, I actually JUST found a better product for my needs, Pulse

    My only problem with Beszel is that it doesn’t know about LXCs within Proxmox, so I can’t see if there are CPU/memory issues happening within them. Pulse integrates directly and can see all of it!

    If you don’t run LXCs within Proxmox, I’d say stick with Beszel.

  • source
  • parent