this post was submitted on 23 Jun 2026
36 points (89.1% liked)

Asklemmy

54938 readers
182 users here now

A loosely moderated place to ask open-ended questions

Search asklemmy πŸ”

If your post meets the following criteria, it's welcome here!

  1. Open-ended question
  2. Not offensive: at this point, we do not have the bandwidth to moderate overtly political discussions. Assume best intent and be excellent to each other.
  3. Not regarding using or support for Lemmy: context, see the list of support communities and tools for finding communities below
  4. Not ad nauseam inducing: please make sure it is a question that would be new to most members
  5. An actual topic of discussion

Looking for support?

Looking for a community?

~Icon~ ~by~ ~@Double_A@discuss.tchncs.de~

founded 7 years ago
MODERATORS
 

I one found this damage on my headphones on both sides, it is unclear what caused it, and the continued uses causes the damage to expand. I'm siriously concerned as I'm sensitive to such issues. The headphones are less than a year old.

top 44 comments
sorted by: hot top controversial new old
[–] MummifiedClient5000@feddit.dk 71 points 3 weeks ago (1 children)

You can buy replacement earpads for most brands of headphones.

Seconded.

And if they're not available for this model/brand, switch to another if possible. There are a lot of headphones with replaceable pads, many of them very affordable.

[–] SkaveRat@discuss.tchncs.de 32 points 3 weeks ago (2 children)
[–] Beagle@lemmy.blahaj.zone 2 points 3 weeks ago (4 children)

Yes, but they are very rounded at that part, so I'm unsure how it could've damaged it.

[–] CmdrShepard49@sh.itjust.works 44 points 3 weeks ago* (last edited 3 weeks ago) (1 children)

Theyre made of cheap "pleather" material that flakes apart with time. I have some expensive headphones that have done the same. You can just buy replacement ear pads and slip them on like a fitted bed sheet.

[–] evasive_chimpanzee@lemmy.world 11 points 3 weeks ago (1 children)

The fake leather is polyurethane, which goes through hydrolysis. Basically humidity destroys the bonds.

[–] lost_faith@lemmy.ca 10 points 3 weeks ago

and sweat is amazingly corrosive

[–] SkaveRat@discuss.tchncs.de 21 points 3 weeks ago

Just the pressure of the frame is enough to cause this. It's a stress point for the material

These kind of pads are not really made to least long. Normally you can replace them

[–] ouRKaoS@lemmy.today 15 points 3 weeks ago

Round things still are subject to friction.

That's like saying "Water is soft and conforming, I'm unsure how it could carve a canyon."

[–] BCsven@lemmy.ca 2 points 3 weeks ago

The fabric is thin and wears out over time from taking them on and off. Mine eventually just crumbled into tiny flakes everywhere

[–] waterbird@lemmy.blahaj.zone 17 points 3 weeks ago (1 children)

do you wear earrings or glasses?

[–] JoeTheSane@lemmy.world 2 points 3 weeks ago

I was also thinking glasses.

[–] whatiswrongwithyou@lemmy.ml 14 points 3 weeks ago (1 children)

It’s normal wear and tear, it’s in those particular spots because you wear glasses.

The cushions or pads are a wear part and are user replaceable.

[–] tiramichu@sh.itjust.works 9 points 3 weeks ago* (last edited 3 weeks ago) (1 children)

I had a pair of headphones where the pads were non-replaceable. They completely disintegrated and turned to dust, and that's when I found they were glued on and not designed for replacement.

It was under 12 months since I bought the headphones so I contacted the manufacturer asking about replacement pads and stating I was happy to pay for them... Only for them to tell me (as I knew they would have to) that the pads are not replaceable and no replacement pads exist.

I was entitled to a replacement under law, and so they had to send me a whole new pair of headphones.

They didn't even make me send the old ones back either, so I ripped the ear pads off and replaced them anyway! And now I have two pairs of headphones for the price of one!

Infuriating manufacturing choice to make consumable wear components non-replacable.

[–] whatiswrongwithyou@lemmy.ml 2 points 3 weeks ago (2 children)

In the future rather than ripping off glued stuff, alcohol and (if you’re very, very careful and understand what you’re doing) acetone can be used to break down glues. A product called β€œca release agent” makes cyanoacrylate glues (superglues) come off.

Heat will also loosen glue that’s thick and rubbery and accelerate the chemical reactions above. Be careful and use ventilation.

[–] whats_a_lemmy@midwest.social 1 points 3 weeks ago* (last edited 3 weeks ago)

Could also try Goo Gone. It's specifically meant for removing adhesives, though I don't think the basic version works on CA glues.

[–] tiramichu@sh.itjust.works 1 points 3 weeks ago

Thanks for the tip. In this case it was fine as the glued part was going to be completely covered by the new pads so any small mess was inconsequential to both the looks and the operation.

[–] LuigiMaoFrance@lemmy.ml 9 points 3 weeks ago

Wear, wear, yeah.

Those cushions wear out after a while, you can buy replacements. Make sure to buy the exact same type and thickness or the sound might be much worse.

[–] jet@hackertalks.com 6 points 3 weeks ago

Buy ear cup replacements off AliExpress for a few dollars.

You can also put on ear booties to cover the headset.

[–] alsaaas@lemmy.dbzer0.com 5 points 3 weeks ago

Can you swap out the padding? If not you made the wrong choice when purchasing the headphones TBH

[–] blackbrook@mander.xyz 5 points 3 weeks ago

Putting a piece of tape (perhaps duct tape, or electrical tape) over the holes will probably keep them from unraveling further.

[–] Feyd@programming.dev 3 points 3 weeks ago (1 children)

It's the elf transformation

[–] Drekaridill@lemmy.wtf 1 points 3 weeks ago

Damn knife-ears

[–] JoYo@lemmy.ml 3 points 3 weeks ago (1 children)

I would have replaced those cushions as soon as I got them. They look really uncomfortable.

[–] Beehaw_Girl@beehaw.org 1 points 3 weeks ago (1 children)

How to replace earphone cushions?

[–] JillyB@beehaw.org 3 points 3 weeks ago

On mine, you can just pull them off

[–] disregardable@lemmy.zip 3 points 3 weeks ago* (last edited 3 weeks ago) (1 children)

They wear out. The unfortunate thing is that the replacement ear pads don't tend to last as long. So buy them if you have to, but keep an eye out for new headphone sales over the next few months.

[–] ChaosMonkey@lemmy.dbzer0.com 4 points 3 weeks ago

Why would replacement pads be worse?

[–] Cherry@piefed.social 2 points 3 weeks ago

Yup replaced mine a few times. Cheap ones are just as good. I add a dot of double sided tape or glue gun to secure.

Pleather/fake leather ear pads do that after continuous use for a long time and it's unfortunately normal. You can change them with new ear pads and if you're lucky, you can find them made by different materials. Be careful, the material of the ear pads actually effects the sound that you will hear from your headphones.

[–] Quill7513@slrpnk.net 1 points 3 weeks ago

i'd see if you can find velour replacement pads. this will reduce the head seal, which will let more sound in and will change the sound signature a little, but it will also last a lot longer for normal day to day use

[–] Denixen@feddit.nu 1 points 3 weeks ago

I have glasses and the same problem, I think the glasses chafe against the plastic leather without one noticing until it breaks.

[–] edinbruh@feddit.it 1 points 3 weeks ago

There's a company that sells "reasonably good" replacement pads for most headphone models, and they include links to tweets and posts of people who bought those pads to prove that they fit properly. I don't remember the name tho

[–] SatyrSack@quokk.au 1 points 3 weeks ago

That's normal wear and tear for over-ear headphones. You should expect for these ear cushions to eventually wear out. They are constantly rubbing against your glasses, earrings, headband, etc. as well as just your ears/head. Unfortunately, they should be considered consumables. Fortunately, as others mention here, there are multiple first-party and third-party replacement pads on the market, so you can replace just the pads as they wear out.

[–] BeUnique@lemmy.zip 1 points 3 weeks ago

I say go extreme with the repair and then post a pic of it. Use Flex Seal on them! You'll never have to worry about them ever falling apart again!

Obviously joking they'd be solid as a rock

[–] Luminous5481@anarchist.nexus 0 points 3 weeks ago* (last edited 3 weeks ago)
  1. A hole
  2. Your ear/glasses
  3. No

Buy a new pair of cups off Amazon or whatever you prefer, they ought to cost you around $5-10. Yours look like the standard egg shape, so just about any should fit. These cups wear out with regular use, which is why they can be removed easily for replacement.